ASTM E pdf – Download as PDF File .pdf), Text File .txt) or read online. Last previous edition E – obtained by applying factors of safety to the ultimate load of 2. Annual Book of ASTM Standards, Vol the anchorage. ASTM E/EM Standard Test Methods for Strength of Anchors in Concrete Elements. standard by ASTM International, 09/01/ View all product.
|Published (Last):||7 December 2018|
|PDF File Size:||14.18 Mb|
|ePub File Size:||13.80 Mb|
|Price:||Free* [*Free Regsitration Required]|
Only those tests required by the specifying authority need to be performed. Astm E PDF Historical Version s – view previous versions of standard. The load and displacement measuring devices shall be capable of zstm data points at least once per second in order to produce continuous load versus displacement curves. The enlarged diameter section of the hole is predrilled or enlarged by an expansion process during setting of the anchor.
E488 superscript epsilon e indicates an editorial change since the last revision or reapproval.
This standard has been approved for use by agencies of the Department of Astj. Astm E – E Worn or deformed holes shall be repaired. Dial gages having an accuracy of FIG. These test methods provide basic testing procedures for use with product-specific evaluation and acceptance standards and are intended to be performed in a testing laboratory. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. The readings shall be obtained prior to reaching peak load. A number in parentheses indicates the year of last reapproval. Insert sleeves of the required diameter shall be periodically installed in the loading plate to meet these requirements.
The initial shape of the hole in the loading plate shall correspond to that of the anchor cross section and shall be FIG.
The loading rod shall be of such size to develop the ultimate strength of the anchorage hardware with minimal elastic elongation and shall be attached to the anchorage system by means of a connector that will minimize the direct transfer of bending stress through the connection.
Last previous edition approved in as E — Only those tests required by the specifying authority need to be performed. Product-specific evaluation and acceptance standards may add specific details and appropriate parameters as needed to accomplish the testing.
For tension tests, displacement is measured along the axis of the anchor, and for shear tests, displacement is measured perpendicular to the axis of the anchor, in mm in. Originally approved in E — 96 FIG.
However, anchor diameters, threads, and related testing equipment shall be in accordance with either inch-pound or SI provisions. Published on Nov View 1.
All Products | GERMANN
No further reproductions authorized. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Get Astm E for free from our online library: The test astk support shall be of sufficient size to prevent failure of the surrounding structural member.
Astm E – e The materials used include epoxy, cementitious material, polyester resin, and other similar types. Astm A – A E — 96 3. Current edition approved May 10, The testing device shall be of sufficient capacity to prevent yielding of its various components and shall ensure that aetm applied tension loads remain parallel to the axes of the asttm and that the applied shear loads remain parallel to the surface of the structural member during testing.
Link to Active This link will always route to the current Active version of the standard.
Get Astm A for free from our online library: Loadings include quasi-static, seismic, fatigue and shock. Nothing in this standard, however, shall preclude combined tests incorporating two or more of these types of loading such as seismic, fatigue and shock tests in series. Work Item s – proposed revisions of this standard.
Environmental exposures include freezing and thawing, moisture, decreased and elevated temperatures and corrosion. The testing may be performed in either system and reported in that system and the results converted to the other. A minimum of data points per instrument shall be obtained and recorded for each individual test.