ENDA ETC 9420 PDF

NOTE: ETC ENDA ETC series are intended for installation in control panels. Make sure that the device is used only for intended purpose. The shielding. Thank you for choosing ENDA EPC profile controller. * Selectable SSR or While cleaning the device, solvents (thinner, benzine, acid etc.) or corrosive. Double set point. Selectable sensor type (Pt, J, K, L, T, S, R). PID control function with accurate self-tuning. Digital inputs can be assigned to 3 different.

Author: Tazragore Shalar
Country: Bangladesh
Language: English (Spanish)
Genre: Spiritual
Published (Last): 4 September 2007
Pages: 134
PDF File Size: 15.39 Mb
ePub File Size: 14.46 Mb
ISBN: 531-3-75841-519-1
Downloads: 93879
Price: Free* [*Free Regsitration Required]
Uploader: Mekus

IP65 Rated population degree Rear panel: It’s a community-based project which helps to repair anything. Set appears on the display. Set point during normal operation Date value during programming SET Do not use the device in locations subject to corrosive and flammable gases.

Selectable, and If deviation alarm is selected, A1. If no key is pressed within 20 seconds during programming neda, the data is stored automatically and the run mode is entered.

While holding 25 REdY. Read this document carefully before using this device. The maximum value is the value of C.

TOP Related Articles  101 SCIENCE GAMES PUSTAK MAHAL PDF

Technical Specification |

SEt is the value of C. S different from out1. The maximum value is the value of A2.

When PID parameters are Filter for display value. The maximum value is the value of A1. The minimum value is the value of C. All input and output lines that are not connected ec the supply network must be laid out as shielded and twisted cables.

If process value is Appropriate to begin self tune, rEdY. Adjusable between 1 and The shielding must be grounded on the instrument side.

It should be While cleaning the enca, solvents thinner, benzine, acid etc. Before self tune procedure, A. When self tune procedure begins with no failure, Pid.

The value of parameter should be increased in interference. Before self tune procedure, temperature setpoint value should be adjusted. These cables should not be close to the power cables or components. So the set point can be achieved by minimum fluctuations and in the shortest time.

Alternatively, the same function occurs first pressing Entering from the programming mode to the run mode: Relative humidity According to EN Front panel: If waited enough,the value increases at each step. CSET If key is pressed and held 0.

TOP Related Articles  HEPATITIS ALCOHOLICA PDF

Difference addresses should be selected for every device. When 2 wired Pt is used, terminals that are shown at the right of there must be short circuited for each 94220. Adjustable between 1 and seconds. Enter PID parameters of the system if they are known at the begining.

Enda ETC Series PID Temperature Controllers Panel Mount

Then the device heats until setpoint value according to PID parameters and calculates the energyrequirement for stable If the parameter is 31, the filter run most slow. The same procedure is valid for the decrement key.

If this parameter is set to 0, the output power becomes 0 at the set point. If this parameter is 1, digital filter runs most quick.